The maintenance of LCD splicing walls in summer is not the same as that in winter. In the case of summer maintenance, the most important thing is moisture-proof and waterproof. Due to a lot of precipitation in summer, it is very prone to the problem of anti-moisture. As everyone knows, the basics are relatively drought in winter, and because drought is very easy to cause dust and static induction, it is necessary to prevent pollution in winter.
Many new projects of LCD splicing walls are all used in well-known companies such as steel, coal mines, etc., whether they are applied in or outside the room, they are very easy to cause excessive dust, especially in dry temperatures, it is easier to enter the LED transparent screen internal. Therefore, in the dry temperature in winter, pay great attention to the removal of the natural environment during the whole process of the application of the 5 LCD splicing wall, try to avoid floating dust, oil stains, etc. into the LED transparent screen, special display can be selected under special circumstances Screen cleaning fluid, scrub the outside of the transparent led screen, reduce the damage caused by dust to the large screen, but remember not to wipe with a wet cloth to prevent short-circuit failure.
In addition, the average temperature in winter is generally slightly lower, especially in northern my country, where the average temperature has been below 0 degrees for a long time. The application of the LCD splicing wall at this temperature will cause great damage to the transparent led screen. Therefore, when the average temperature is below -20, you must pay attention to the standby and stop operation, and wait until the ambient humidity reaches the ambient humidity during work and restart the work.
Although the LCD splicing wall has been rigorously tested in the original factory, it is basically not easy to find abnormalities without special circumstances. If the display information is abnormal due to poor actual operation or other reasons during the entire application in winter, and If you cannot handle it independently, you should immediately contact the installation professional and technical personnel, and wait for the project engineer to remotely control the control or on-site service processing.
